Our CMP CMP24175SR 175 Watt Monocrystalline Walkable SunPower Maxeon Gen III Cell Solar Panel uses premium SunPower Maxeon Gen III solar cells and will perform extremely well in both full and partial sun.
The CMP CMP24175SR 175 Watt Monocrystalline Walkable SunPower Maxeon Gen III Cell Solar Panel is built to withstand the harsh marine environment and is ideal for mounting on a rigid boat surface or a camper van roof.
The CMP24175SR solar panel measures 36.4 x 37.6 inches.
The CMP CMP24175SR 175 Watt Monocrystalline Walkable SunPower Maxeon Gen III Cell Solar Panel is specifically designed to be walked on!
With a strong aluminum backing and extra thick ETFE laminate non-skid surface, these exclusive solar panels can be walked on without fear of damaging the solar cells and can conform to a slightly curved surface (~5 degrees). These panels are ideal for mounting on a slightly curved rigid boat, camper van van roof, roof rack, boat dock, or on our top-of-pole mounting system.

CMP CMP24175SR 175 Watt Walk-On SunPower Maxeon Gen III Solar Panel Specifications:
Panel Type: Class A Monocrystalline 49 SunPower Cells
Rated Power 175 Watts
Peak Power Voltage (Vmpp) 29.4 Volts
Peak Power Amps (Impp) 6.0 Amps
Open Circuit Voltage (Voc) 34.7 Volts
Short Circuit Current (Isc) 6.4 Amps
Cell Conversion Efficiency 23.7%
Manufacturer’s Warranty 1 Year @ 80% + 4 Yrs prorated
Dimensions 36.4″ X 37.6″
924mm X 955mm
Weight 18 pounds, 8.2 kg
Output Connections: 6 foot (2 meter) duplex cable 3/8 inch OD
Mounting Semi-rigid Walk-On Marine Solar Panels
Our CMP Semi-Rigid Walkable Solar Panel Mounting Kit includes two ‘J’ anodized aluminum extrusions. The CMP Semi-Rigid Walkable Solar Panel Mounting Kit is available in Anodized Black aluminum, or raw aluminum.
You will need to specify our solar panel model number when ordering so that the proper length extrusions are included with your order.
There are at least three ways to mount the semi-rigid solar panels on a rigid surface.
- They can be screwed down directly to the deck surface at each corner. We recommend a stainless screw with an oversized washer.
- They can be taped down directly to the deck with double sided Very High Bond (VHB) tape. Because the back side of the panel has a pebbled surface like the front side for air circulation, the tape must have a foam core of at least 1/8 inch to secure the panel.
- The third method is our preferred method: Our CMP Semi-Rigid Walkable Solar Panel Mounting Kit. Aluminum extrusions are mounted on each side of the long sides of the panel and adhered to the deck surface with the tape. If the deck surface is not conducive to adhering the tape, the ‘J’ extrusions can be screwed to the deck and the panel slid into position. This mounting method allows for the panel to be slid out of the extrusion for removal and cleaning of the deck surface.