Are you as frustrated as we are that your Mercedes Sprinter van folding mirrors don’t fold in automatically like every other Mercedes vehicle does? The brand new Mid City Automatic Folding Mirror Programmer for 2019+ Mercedes Sprinter from Nomadic Supply Company is our solution to this oversight by Mercedes. Nomadic Supply Company worked with our friends at Mid City Engineering to bring this product to you.
The brand new Mid City Automatic Folding Mirror Programmer for 2019+ Mercedes Sprinter from Nomadic Supply Company is locked to the VIN of the vehicle so if you lose the programming you can easily reprogram with the unit.
Mid City Automatic Folding Mirror Programmer for 2019+ Mercedes Sprinter Programming:
The programming options are determined by the position of the turn signal/high beam stalk during the programming sequence.
- To select a programming option, put the stalk in the corresponding position before starting the programming sequence.
Option 1 (default): Stalk neutral
- Mirrors fold in with lock from OEM key fob, fold out with unlock from OEM key fob.
Option 2: Stalk down/left turn signal
- Mirrors fold in with lock from OEM key fob, mirrors fold out when door is opened.
Option 3: Stalk up/right turn signal
- Return to OEM settings
Note: the OBD programmers are for use in 1 vehicle. Once the programmer is used, it can only be used in the same vehicle again.
The Mid City Automatic Folding Mirror Programmer for 2019+ Mercedes Sprinter works with:
2019+ Mercedes-Benz Sprinters with electronically folding side mirrors.
Mid City Automatic Folding Mirror Programmer for 2019+ Mercedes Sprinter Installation:
Step 1
Select programming option and cycle ignition on and off
Set turn signal stalk position to choose programing option. For default programming, leave stalk in neutral position. See above introduction above for programming option selection.
Press push to start button 2X to turn on ignition
Do not start engine
Ignition is the 2nd position, all warning lights will be on instrument cluster
Press push to start button 1X to turn ignition off
This step is to wake up the vehicle
Step 2
Plug in OBD programmer
Plug OBD programmer into OBD port
LED should turn on (inside case, look through hole at the end of the case)
Step 3
Turn ignition on confirm programming
Press push to start button 2X to turn ignition on
Check LED inside programmer
When LED turns off, programming is complete
Sometimes the programming occurs very quickly (LED turns off immediately after ignition is turned on)
If LED does not turn off within 5 minutes, repeat programming steps- but try to complete steps 2 and 3 within 10 seconds.
Do not start engine
Ignition is the 2nd position, all warning lights will be on instrument cluster
Step 4
Turn off ignition and remove programmer
Attention: The OBD programmer should be removed after use. Do not start engine or drive vehicle with OBD programmer installed.