The Mercedes Sprinter now has CRL ‘All-Glass’ Look Sprinter Van Windows to complement their great design. CRL FW623L Mercedes Sprinter 170″ Rear Quarter Dual-Vent Windows from Nomadic Supply Company are configured to fit within the OEM stampings and provide a customized OEM look. This great feature eliminates the time consuming efforts of laying out where the window will be installed. Just line it up to cut, starting on the upper inner dimple and follow along the OEM stamping!
Dual Vent has a Two T-Handle to open the bottom vent glasses like a canopy to allow air flow, the Vent features a detachable screen. (both bottom panels open!)
We recommend securing this window against break-ins with our:
CRL FW623L Mercedes Sprinter 170″ Rear Quarter Dual-Vent Window (Driver Side) Specifications:
- Manufacturer Country: USA
- Manufacturer Warranty: 30 Days
- Glass Color = Solar Privacy Glass
- Part Number: CRL FW623L
- Fits 2007+ Mercedes Sprinter 170″ wheelbase
- Has 28% dark gray factory tint
- Has a clamp (trim) ring, so does not require adhesive, primer or sealant
- Uses tempered glass for maximum safety and strength
- Is tested to ANSI Z26.1 and FMVSS 205 safety standards
- Uses factory stampings for cut lines
- Is manufactured in the USA by C.R. Laurence.
How will I install this window?
The CRL FW623L Mercedes Sprinter 170″ Rear Quarter Dual-Vent Window (Driver Side) utilizes the factory metal stamping, on the interior of the van you will notice an area where the inner metal ends. Here is a photo to clarify. You will cut right along that edge all the way around your van may have multiple upright you will cut those out straight with your opening.
When replacing an existing factory window, you may want to contact us or provide photos inside and out. Not all replacements will be straightforward and can require extra commendation and custom adaptation to use an existing factory or add-on item(s). Van Windows Direct and the manufacturers we distribute take no responsibility for additional work or an installer’s inability to complete the work required. Please ask all questions and provide all information before purchase, as the buyer is 100% responsible for the installation or failure to install.
If you are replacing an existing factory window that glued in you may want to take to a professional for removal and replacement. Best tool to use is a wire cutter Equalizer Window Cut-Out Set . Once the window is cut out you will need to cut the original urethane down as flat as possible and clean as much away as you can CRL Adhesive Cleaner .
Once the Hole has been cut out or window removed its time to install the new window.
The CRL FW623L Mercedes Sprinter 170″ Rear Quarter Dual-Vent Window (Driver Side) utilizes a trim ring (clamp ring) installation. Before putting the window on the van its best to go through make a small pilot hole in all the locations around the trim ring that way you do not round the heads of the screws when tightening the window.
Put Window in place from outside of Van allowing the aluminum mounting frame to extend through hole in wall. Place clamp ring from inside most vans will have the split on the bottom. With one person holding window in place on the outside the other can start a the screws from the inside generally start with the two at the split in the trim ring to have that lined up then top and around you do not want to fully tighten once all screws are in place, you can then go back around and tighten them be sure to tighten evenly around for proper seal.