The Wilco Offroad Hitchgate Offset Spare Tire Carrier for Left/Driver Side (UHG3060) from Nomadic Supply Company universally fits on virtually all vehicles and camper vans with a Class III hitch receiver. This swing-away spare tire carrier mounts to any 2-inch receiver and is perfect for SUVs and overlanding vehicles.
The Wilco Offroad Hitchgate Offset Spare Tire Carrier for Left/Driver Side (UHG3060) carrier secures up to a 40-inch spare tire while maintaining ground clearance, and minimal change in departure angles when driving off-road. By releasing a single latch pin, you can swing the tire carrier out of the way to fully access the vehicle’s cargo space. The Wilco Offroad Hitchgate Offset Spare Tire Carrier also maintains the vehicle’s towing capabilities with an integrated Class IV receiver.
Wilco Offroad Hitchgate Offset Spare Tire Carrier for Left/Driver Side (UHG3060) Features:
- Integrated Hi-Lift mount and hardware
- Bolt-Action Anti-Swing Pin
- Secondary Compression Latch for Extra Strength and Security
- RotopaX compatible fuel mount options
- Carry up to a 40-inch tire on full size trucks
- Compatible with most vehicles equipped with a 2-inch hitch receiver
- Maintain access to receiver for towing and hitch-mounted accessories
Wilco Offroad Hitchgate Offset Spare Tire Carrier for Left/Driver Side Important to Know:
- Zero offset or shallow offset (high positive offset) wheels may require an additional wheel spacer.
- 4.5″ of clearance required from center of hitch pin hole rearward for it to be compliant with wedge lock system. You may need to relocate spare tire from underneath or modify to gain the necessary clearance.
- The Wilco Offroad Hitchgate Offset Spare Tire Carrier for Left/Driver Side is not compatible with vehicles with Clam-Shell Rear doors (Toyota Land Cruisers, Lexus LX Series, Etc.)
- Vehicles need at least 10.5″ of clearance from top of hitch to bottom of rear door/tailgate
Gas/Fluid/Tool Accessories
- Dual RotopaX Mount (DRPM33470)
- Wilco Horizontal Low-Rise Mount for Hi-Lift Jacks (DAN32211)
- Hi-Lift 48″ X-TREME Vehicle Recovery Jack (XT-485)
- Hi-Lift 60″ X-TREME Recovery Jack (XT-605)
Towing/Compliance Accessories
- Wilco Offroad 2.5″ Trailer Hitch Adapter (Allows for a functioning wedgelock in a 2.5″ hitch)
- Wilco Offroad Wobble-Free 2″ Trailer Hitch Extender
- HitchFire Locking Trailer Hitch Pin
- Master Lock Barbell Receiver Hitch Lock
- Master Lock Barbell Extended-Length Receiver Hitch Lock (recommended for 2.5″ hitches, Tacoma/Tundra/4Runner)
**Notice of maintenance required**
Periodic tightening of the pivot bolt with a torque wrench to at least 60-70lbs every few months is needed to prevent movement on the swing arm. Over time, replacing the Delrin washers and T handle bushings may be necessary.